Trendnet TEG-082WS Betriebsanweisung PDF herunterladen (Seite 111)

TRENDnet User’s Guide TEG-082WS

Troubleshooting

Q: I typed http://192.168.10.200 in my Internet Browser Address Bar, but

an error message says “The page cannot be displayed.” How can I access the

switch management page?

1. Check your hardware settings again.

2. Make sure the Power and port Link/Activity lights are lit.

3. Make sure your network adapter TCP/IP settings are set to use the static

IP.

4. Make sure your computer is connected to one of the Ethernet switch ports.

5. Since the switch default IP address is 192.168.10.200, make sure there are

no other network devices assigned an IP address of 192.168.10.200

If my switch IP address is different than my network’s subnet, what should I

do?

You should still configure the switch first. After all the settings are applied, go

to the switch configuration page, click on System, click IPv4 Setup and change

the IP address of the switch to be within your network’s IP subnet. Click Apply,

then click OK. Then click Save Settings to Flash (menu) and click Save Settings

to Flash to save the IP settings to the NV-RAM.

I changed the IP address of the switch, but I forgot it. How do I reset my switch?

Using the TRENDnet Samrt Switch Management Utility to find your smart

switch. Or, you can reset your smart switch to factory default.

To reset the smart switch, using a paper clip, push and hold the reset button

on the front of the switch and release after 15 seconds. The default IP address

of the switch is 192.168.10.200. The default user name and password is

“admin”.

1 2 ... 106 107 108 109 110 111 112 113 114 115 116 ... 122 123

Keine Kommentare

Trendnet TEG-082WS Betriebsanweisung Seite 111